Ich habe in meinem Auto ein altes IceLink Crade (damals für iPod 3. Gen), welches noch über FireWire lädt.
Jetzt möchte ich das Cradle gerne für mein iPhone nutzen, welches zwar als Audio-Out läuft, aber natürlich nicht geladen wird.
Pinbelegung ist bekannt (Klick). Frage ist jetzt, ob es reicht die Stormversorgung auf 5 VDC (+) (Pin 23) mit entsprechendem Vorwiderstand zu legen, oder ob ich noch was beachten muss.
Hat evtl jemand Erfahrung damit?
Auf der Pinout-Seite steht noch
Denke, das sollte auch beachtet werden, oder?
Jetzt möchte ich das Cradle gerne für mein iPhone nutzen, welches zwar als Audio-Out läuft, aber natürlich nicht geladen wird.
Pinbelegung ist bekannt (Klick). Frage ist jetzt, ob es reicht die Stormversorgung auf 5 VDC (+) (Pin 23) mit entsprechendem Vorwiderstand zu legen, oder ob ich noch was beachten muss.
Hat evtl jemand Erfahrung damit?
Auf der Pinout-Seite steht noch
iPod Nano 4th Gen no longer will charge from 12 volts on the firewire pins. If you tie pins 25 and 27 together through a 10K ohm resistor while applying +/- 5 volts to pins 23 and 15 (or 16) that it will charge. If you don't tie 25 and 27 together, it won't charge.
iPod Touch 2G requires pin 11 connected to 15/16, then connect that to pin 21 with a 68kOhm resistor to use the audio line out. This is because the device needs to be told to redirect the signal to the Line Out pins rather than to the built-in speaker. This explains why certain accessories won't work with the iPod Touch 2G and maybe even the iPod Touch 3G.
Denke, das sollte auch beachtet werden, oder?